Tools Required
· Philips Head Precision Screw Driver
(recommended size: PH0)
· Tweezers
Installing Your Grips (part 1)
· Using tweezers, carefully peel off the
yellow covering on the self-adhesive pad.
· Do this for all four grip halves.
Installing Your Grips (part 2)
Installing Your Grips (part 2)
· Attach the grip halves to the wheel plate using
the No.2 (2.2mm x 13mm long) Self Tapping
Posi Pan Head Screws provided.
· When screwing the new grips together, make
sure the rear grips are seated into position
properly. If they are not and you try to screw
the top half on, you may damage/thread strip
the holes that receive the self-tapping screws.
· DO NOT OVER TIGHTEN THE SCREWS!
Tighten the screw until you see the two grip
halves come together and you feel an
obvious “stop” feeling resistance. If you over
tighten, there is a risk of thread stripping
the holes.
Tools Required
Installing Your Grips (part 1)
Installing Your Grips (part 1)
· Philips Head Precision Screw Driver
(recommended size: PH0)
· Tweezers
Installing Your Grips (part 1)
Installing Your Grips (part 1)
Installing Your Grips (part 1)
· Using tweezers, carefully peel off the
yellow coverings on the three self-
adhesive pads.
· Do this for all four grip halves.
Installing Your Grips (part 2)
Installing Your Grips (part 1)
Installing Your Grips (part 2)
· Attach the grip halves to the wheel plate using
the No.2 (2.2mm x 13mm long) Self Tapping
Posi Pan Head Screws provided.
· When screwing the new grips together, make
sure the rear grips are seated into position
properly. If they are not and you try to screw
the top half on, you may damage/thread strip
the holes that receive the self-tapping screws.
· DO NOT OVER TIGHTEN THE SCREWS!
Tighten the screw until you see the two grip
halves come together and you feel an
obvious “stop” feeling resistance. If you over
tighten, there is a risk of thread stripping
the holes.
Tools Required
Installing Your Grips (part 1)
· Philips Head Precision Screw Driver
(recommended size: PH0)
· Tweezers
Installing Your Grips (part 1)
Installing Your Grips (part 1)
· Using tweezers, carefully peel off the
yellow coverings on the circular self-
adhesive pad.
· Do this for all four grip halves.
Installing Your Grips (part 2)
Installing Your Grips (part 2)
· Attach the grip halves to the wheel plate using
the No.2 (2.2mm x 13mm long) Self Tapping
Posi Pan Head Screws provided.
· When screwing the new grips together, make
sure the rear grips are seated into position
properly. If they are not and you try to screw
the top half on, you may damage/thread strip
the holes that receive the self-tapping screws.
· DO NOT OVER TIGHTEN THE SCREWS!
Tighten the screw until you see the two grip
halves come together and you feel an
obvious “stop” feeling resistance. If you over
tighten, there is a risk of thread stripping
the holes.